Anti Roll Bar Install (a few pics)

[4pnt6]

Not too many detailed pics here. Got a Racecraft Inc ARB cause it was removable and my car is driven 90% on the street. If one of the bearings wears out it can easily be replaced. I had to modify the plates that weld to the framerails. They have provisions on the backside for the upper torque box sheet metal to fit behind them but it wasn't enough. Just had to mill some material off and make the provisions bigger. Don't have any pics of that.

I need to keep my good camera out in the shop. All I usually have is my phone. These pics suck!

Tacked in.




Torque boxes looked like ass so I tried to clean em up.

[4pnt6]

Here it is installed. I was mocking up my exhaust. Building a 3" stainless system to go around the ARB with tailpipes. It's all done I just don't have the pics with me right now. I'll make a thread when I have access to them.

[Dan03mach]

Looking good...