When installing springs, the bottom pigtails in the rear need to point towards the driver and the pigtails in the front need to sit in between the holes in the control arm, right? Or does it not really matter?
Announcement
Collapse
No announcement yet.
Spring install
Collapse
X
-
If you’re using lowering springs they come with instructions. Like I said though you can get the car to go up and down by spinning them. Measured from my fender to the floor. Then spun them until both sides were the same and where I wanted it. So on my car they’re different on both sides. But the ride is level side to side.
Comment
Comment