Announcement

Collapse
No announcement yet.

Spring install

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Spring install

    When installing springs, the bottom pigtails in the rear need to point towards the driver and the pigtails in the front need to sit in between the holes in the control arm, right? Or does it not really matter?
    Last edited by A+; 06-07-2019, 11:59 AM.
    .....bro....

  • #2
    There’s a perch on the front that they need to sit in. On the rear they should point to the rear. I spun the rear ones until I got the stance I wanted. I used isolators on the rear. None on the front.

    Comment


    • #3
      I read the rear needs to point to the back, then I read that they should point to the driver side[emoji2375]
      .....bro....

      Comment


      • #4
        If you’re using lowering springs they come with instructions. Like I said though you can get the car to go up and down by spinning them. Measured from my fender to the floor. Then spun them until both sides were the same and where I wanted it. So on my car they’re different on both sides. But the ride is level side to side.

        Comment


        • #5
          Spring install

          Thanks!
          .....bro....

          Comment

          Working...
          X