Mini-tubs

[Sleeper]

Its just a small mpt70 isnt it? There was a couple guys on the turbo forums back in the day with big singles on your year car.

Ive never looked at how the vintage stangs are made. I just know foxes.

[Sleeper]

Its just a small mpt70 isnt it? There was a couple guys on the turbo forums back in the day with big singles on your year car.

Ive never looked at how the vintage stangs are made. I just know foxes.

[Z06killinsbf]

Yes but most of those guys don't have ac and my lines run right where they're running their down pipes.

[Z06killinsbf]

Where all the shit needs to fit

[Sleeper]

Are you wanting to run it all the way to the back?

Would there be a way to have the compressor side facing the alt and run the downpipe inside the fender and loop it back under?

What ive learned looking at turbo set ups over the years. There is a way to do everything, Just gotta dream it up.

With your skills you will find a way.

[Z06killinsbf]

Thanks for the confidence! I need to rotate the alternator up high because the manifold output dumps into the back if it then figure out driver side. I would like to try to avoid running anything under the frame as much as possible. If I put the charger with exhaust side in fender I'll run it over the tire and back into the engine bay after the shock tower

[Sleeper]

would there be room to run it back underneath the manifold once you move the alt up?

[NoClassic]

I would consider finding a new path for the A/C lines before doing any major modification to the body. Crimping new lines is cheap and refrigerant recovery/fill would be all of $100 or so.

[Z06killinsbf]

Not sure where else they would go. I could flip the condenser over and route the lines to the driver side but I'm not sure how that would affect the driver side hot side.

[Z06killinsbf]

How effective would this ebay 70mm be in a remote mount setting? I'm thinking maybe where the muffler sit right now. Opinions?

[Sleeper]

Only one way to find out haha.

[Z06killinsbf]

Is the top bell housing for a TKO? Numbers say T5 but my trans doesn't fit it.

[Sleeper]

I remember the threads being different for my 3550 bell housing.

Google the part numbers.

[Z06killinsbf]

I did, it's supposed to be a T5 housing

PN e6zr-6394-aa

Trans PN f4zr-7003-ac

The bolt holes don't line up

[black2002ls]

Maybe with a little bit of help from an A-dapter kit?