Kel Tec Sub 2000 9mm

[FATHERFORD]

You pick which one you want. G17 or 19.

They also have multiple finishes avail. I ordered the one in the pic, coyote tan. Was told it could be 6 to 8 mos.

Has it always been this way?

Why would anyone want a g17 version then? Just get the G19 and use all the mags.

I got mine from a guy that bought it, then realized he didn't have the money.

[dblack1]

I've got one. Got it from cdnn. They get quite a few, but it took me a few tries to finally catch them at right time.

I like it, neat gun, glock mags, small when folded.

[FastFord19]

I'm Keltec white trash... P40, PF-9, and SU-16...

I want a sub2000 too

[Cobraman]

As with anything keltec.

Negative....



You can find a p3at in your local trashcan

[Semper299]

Should take glock 17 mags not 19.... Unless they changed it up some.

19's are too short.

You pick which one you want. G17 or 19.

They also have multiple finishes avail. I ordered the one in the pic, coyote tan. Was told it could be 6 to 8 mos.

[CJ]

I wanted one, but proved hard to get

As with anything keltec.

[Cobraman]

I wanted one, but proved hard to get

[IdabelBlue]

YouTube that bad boy. Great videos over them

[IdabelBlue]

Had a chance to trade for one and the guy was acting too shifty...I had some plans for it. Rotating forend, sights, paint, and a nice stipple job...damn....

[Semper299]

Awesome. Thanks for the input.

[FATHERFORD]

Should take glock 17 mags not 19.... Unless they changed it up some.

19's are too short.

[GrayStangGT]

I've got one, it is a blast for plinking and the plastic iron sights are surprisingly accurate. 9mm with glock mags is the only way to go so you can get the 33 rounders.

[YALE]

I've always had an eye out for one in 9mm, set up for P226 mags, but I'm not going out of my way for it.

[Semper299]

Anyone have experience with this gun.




The one I am looking at takes glock 19 mags, including the 33 rounders. I have read good stuff about them. They also make one in .40 cal.