racrguy

I picked up a set cheap, I have a custom ground cam for my setup. I like the sewing machine sound, I've been running hyd rollers for the past 10 years, wanted a change. I limit at 6600 so it's not a high rpm setup. I'm running kmotion 800 springs with 150 at the seat and I'm going to give it a try eventually with brad penn oil.

you have any experience with tool steel flat tappets dlc coated? more exactly what seat pressure can I run on a cast cam

That is one sexy beast in your avatar, just sayin'!

Hey man!

Oh, but that's where you're wrong!

You ain't even doing anything!

Say fool!

are you drunk?

I'll be sure to send some steel wool via fedex. That's all I can promise.

Hope you like seconds...just being honest.