295/45/17 MT's on a Fox body

[Junkie]

Anybody run them? Any pics?

[SSsierra90]

I run 315s on my coupe

nitto DRs

[Junkie]

Thats a 26 inch tire though isnt it? These are nearly 28 inches tall

[SSsierra90]

Ya you would probably have some clearence issues with the fenders. I had to roll mine and sometimes they still rub with body roll. Probably would depend on your ride height too.

[Junkie]

Ya you would probably have some clearence issues with the fenders. I had to roll mine and sometimes they still rub with body roll. Probably would depend on your ride height too.

I'm on 275/60/15's now. The 295/45/17's are about an inch shorter and about .5" wider.

[SSsierra90]

If your clearing that then should have no problem other than the quad shock with the width. I removed mine.

[XR_1]

Thats a 26 inch tire though isnt it? These are nearly 28 inches tall

This is what I use to make sure something fits based on what is on there
It is pretty accurate

http://www.rimsntires.com/specs.jsp

[Junkie]

This is what I use to make sure something fits based on what is on there
It is pretty accurate
http://www.rimsntires.com/specs.jsp

What offsent are weld draglites on a fox body? its a 15x8 in the rear.

[CRASH]

What offsent are weld draglites on a fox body? its a 15x8 in the rear.

You can get the 15x8's with either a 4.5" or 5.5" backspacing. The 8's that were on my green car (now belongs to Yale) had 5.5" and 275/50-15's and they scraped every once in a while.

-Aaron