Announcement

Collapse
No announcement yet.

helicopter crash in auckland

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • helicopter crash in auckland




  • #2
    holy shit...and I bet he did too

    Comment


    • #3
      Did the rotors hit something or was it a mechanical failure? There is a ton of hazards around him but watched in slow motion and couldn't tell for sure what happened.

      Comment


      • #4
        Found the answer to my question.

        http://tvnz.co.nz/national-news/heli...eckage-4564078

        Comment


        • #5
          Yep the vid in your link shows a good view of the cable hitting the blades. Guy was a dumbass for operating that close to the cables.....

          Comment


          • #6
            bejusus.... the vibration alone from a blade strike like that probably broke his neck. Farly solid helicopter otherwise, when you are not hitting shit with it.

            Comment


            • #7
              Lol at the guys tripping over each other.

              On a side note...did everyone record this chopper going down?

              Comment


              • #8
                Bet he needs new underwear.

                Comment


                • #9
                  If you pay close attention in the first vid you can see the whole rotor shaft lifts up and out right after the hit, which then appears to have caused quite a shimmy from hell as it rolled over and went down.
                  70' Chevelle RagTop
                  (Forever Under Construction)



                  "Opportunity is missed by most people because it is dressed in overalls and looks like work.”- Thomas A Edison

                  Comment

                  Working...
                  X