My 90 BlueCoupe build project

[BlueCoupeRedVert]

looks good, doug.

Thanks Tim! Its getting there. Lol

[BlueCoupeRedVert]

Got some new shoes for the Coupe. Traded my cobra Rs for some weld Prostars.

[dville_gt]

[IMG][/IMG]

are those lines fully assembled? looks like there is a gap between the compression nut and the fitting

[BlueCoupeRedVert]

are those lines fully assembled? looks like there is a gap between the compression nut and the fitting

Nope. That was a test fit. They are now fully assembled.

[BlueCoupeRedVert]

current state of the car..

[IMG][/IMG]

[SEB]

Dang Doug done stepped up! Power BABY

[BlueCoupeRedVert]

Dang Doug done stepped up! Power BABY

Lol, thanks. I just finish the front brake swap between my two cars. I put the 03 Cobra brakes on the Vert, and the 02 GT brakes on the Coupe. Now the Prostars fit on the Coupe.

[BlueCoupeRedVert]

got a lot of work completed on the engine harness. its cut down to the bare minimum. Removed the salt and pepper shaker plugs. still have to loom it.

[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]

[BlueCoupeRedVert]

loomed...
[IMG][/IMG]

[dville_gt]

while i like the way that fuel pressure gauge looks (symmetry wise), wouldn't it make more sense to put a 90* fitting on it and bring it out to one side or the other since once you get the hat on that throttle body you won't be able to read the gauge at all?

[BlueCoupeRedVert]

while i like the way that fuel pressure gauge looks (symmetry wise), wouldn't it make more sense to put a 90* fitting on it and bring it out to one side or the other since once you get the hat on that throttle body you won't be able to read the gauge at all?

That's what I plan on doing. I get my hat this week. Then I will play with it. I even thought about putting a gauge facing each side of the engine. Lol. Or just a smaller gauge. But the one on it now is only temp. Works fine but the needle is bent.

[dville_gt]

That's what I plan on doing. I get my hat this week. Then I will play with it. I even thought about putting a gauge facing each side of the engine. Lol. Or just a smaller gauge. But the one on it now is only temp. Works fine but the needle is bent.

Just run a short piece of braided line up to the cowl and put it where you can see it while driving.

[Cobraman]

He doesn't have a cowl hood if that's what you meant.

[BlueCoupeRedVert]

He doesn't have a cowl hood if that's what you meant.

The "cowl" is the space between the end of the hood and the bottom of the windshield. I am think about getting one of those molded cowl vents that houses two gauges.

[Cobraman]

The "cowl" is the space between the end of the hood and the bottom of the windshield. I am think about getting one of those molded cowl vents that houses two gauges.

oh, cool