k member swap

[BlueCoupeRedVert]

Tonight we got the AJE k member pulled from the Cobra and installed into the 86. So progress has started again... Lol

[Tremor14]

I saw you a couple weeks ago while i was sitting at the light at keller springs/josey, that blue sn95 is a head turner for sure.

[BlueCoupeRedVert]

I saw you a couple weeks ago while i was sitting at the light at keller springs/josey, that blue sn95 is a head turner for sure.

Thanks

[Baron Von Crowder]

Updates?

[BlueCoupeRedVert]

I found a cheap ls1/2 car intake so it will fit under stock hood.

[Sleeper]

Aje k member right? truck intake will fit if you wanted

[BlueCoupeRedVert]

Aje k member right? truck intake will fit if you wanted

When it was all mounted in the Cobra, it didn't look like it was going to fit.. Bet there is less clearance in the 86.. Most likely we will get it running as is with the truck intake first.

[Sleeper]

To fit the ls1 intake, you need to modify the alt bracket. It needs a part cut out of it, and for best fitment 08 and up truck water pump. No having to beat the inlet for clearance for the throttle cable. A little modding of the steam vent tubes under the intake as well.

Buy the dirty dingo idler set up as well.

You can use the factory a/c tensioner as well with some trickery.

[Cobraman]

To fit the ls1 intake, you need to modify the alt bracket. It needs a part cut out of it, and for best fitment 08 and up truck water pump. No having to beat the inlet for clearance for the throttle cable. A little modding of the steam vent tubes under the intake as well.

Buy the dirty dingo idler set up as well.

You can use the factory a/c tensioner as well with some trickery.

Alt bracket is getting modded. Motor is an 07 so the wp is fine. We are test fitting today

[Sleeper]

nice. You still have that 76 on3 to throw on it?

[Cobraman]

nice. You still have that 76 on3 to throw on it?

Never bought one. Going to run it stock for a while. Iron out all the kinks and replenish funds.