Mini-tubs

[Sleeper]

if those are the part numbers they should work together.

But the bottom bell housing looks like the correct bolt set up for a t5 if i remember right. Its only been like 14 years.

[Sleeper]

http://www.latemodelrestoration.com/item/M6392E/83-93-Mustang-Ford-Racing-T5-Bellhousing

Drill and tap the bottom hole. look the same otherwise.

[Cooter]

top bell looks like Tremec/SROD

[Z06killinsbf]

So does that mean I can drill a hole and heli-coil it then? What I'm finding is the SROD is identical to the T5 by with different holes drilled. Correct?

Thanks guys

[Z06killinsbf]

Closer investigation they're way off.

Anyone want to swap me a bell housing!?!?

[Scott Mc]

Nope lol

[Sleeper]

Shouldnt be hard to swap a tremec bell for a t5

[Z06killinsbf]

Well, I did this

[projectPONY]

I like those wheels! Bellhousing is in the truck BTW.

[Z06killinsbf]

I had a run in with a horribly shitty fitting conversion crossmember but thanks to Swampdonkey I was able to get a new crossmember from him that actually fits!! Baby steps



Also, I still don't have a build thread yet....

[Wanderer]

The gold looks good on the blue. I see the primer on the back of the car.....are you going to go back with the blue or something else ?

[cool cat]

What brand crossmember didn't fit, I'm about to get one for my 68.

[Z06killinsbf]

The gold looks good on the blue. I see the primer on the back of the car.....are you going to go back with the blue or something else ?

Thanks, yes most likely it will go back grabber blue.

What brand crossmember didn't fit, I'm about to get one for my 68.

I'm not sure, I bought it years ago off eBay.

[Baron Von Crowder]

FWIW, the one I bought at DM fit fine.

[Wanderer]

Thanks, yes most likely it will go back grabber blue.

That's good. I think the colors go well together. Usually when I see gold wheels I immediately think ricer, but they actually work well on your car.