Rebuild 4L60E

[BP]

Why would servos need to be replaced? New orings/rings and slap them back in. The only parts needed for a basic build should be clutches/steels, band and gaskets as far as I know unless the unit is thrashed then probably some hard parts.

If you have an old AOD the OD servo is plastic and it'll crack at WOT with any kind of power. Or if you have the smaller servo on a 4L60 the "Corvette" one can increase apply pressure considerably. Otherwise though unless they are cracked or worn out there isn't really a reason.

[Lason]

Oh ok, I have never seen a plastic servo so I didnt know that. Makes sense though.

[War Machine]

Ok I called the guy asking 400 for the rebuild, told him you guys thought he was too cheap, he said he will gladly do it for 1000 no problem


so, problem solved, I mean if you call him, he might consider 900

[forbes]

should be around 1k for a decent build. but for my truck i went ahead and did the transgo kit, replaced all the servos with billet and did the 4l65 sunshell. the prices on just those were just 400. i did mine in the garage myself.... never again

[john98gt]

call this guy. names chase 8177916985. he does awesome work

[forbes]

call this guy. names chase 8177916985. he does awesome work

chase... didnt he have a forged 408 in a blue truck? if so he does do good work

[john98gt]

yepp thats him. tell him john with the turbo gt snet ya. i used to work with him. he does awesome work an is reasonable

[Trick Pony]

yepp thats him. tell him john with the turbo gt snet ya. i used to work with him. he does awesome work an is reasonable

Cool, I'll give him a call. Where is he located?

[john98gt]

on the west side of fort worth