Tweet
I have an 89 gt with a qa1 tubular k member my steering shaft seems to be too short now. Has anybody ran into this? What is the fix for this? If I buy a flaming river rack and shaft will I have the same issue?
-
-
I have an AJE k member and the stock steering shaft is too short. My flaming river shaft came in today and you adjust it to how ever long you need. It has set screws and you dimple the shaft with 1/4" bit to where ever you need the length to be.Originally posted by skinnystangman View Post -
the steering column is telescopicRing and pinion specialistComment
-
WAT ?Originally posted by greenbullitt View Post
You need to get a flaming river steering shaft. I had the same issue when I, like , went totally tubular man !!!Vortex rear stand $75
8.8 410s. $50
**SKAGG NASTY**
My goal in life is to not arrive at the grave in a well preserved body.
but rather to skid in sideways, totally worn out, shouting "holy shit!!!.. what a ride!"
1990 Foxbody GT for that ass
11
4 door
13 FX2 White 5.0Comment
-
yes, the fr shaft is the way to go, but the columns are telescopicOriginally posted by Txstang1 View Post
Ring and pinion specialistComment
-
oh duh, I see what you did...lolOriginally posted by greenbullitt View Postyes, the fr shaft is the way to go, but the columns are telescopicVortex rear stand $75
8.8 410s. $50
**SKAGG NASTY**
My goal in life is to not arrive at the grave in a well preserved body.
but rather to skid in sideways, totally worn out, shouting "holy shit!!!.. what a ride!"
1990 Foxbody GT for that ass
11 4 door
13 FX2 White 5.0Comment
-
They are tight sometimes. Use a prybar and it will slide out but a fr setup is the way to go especially if you have long tubes.Comment
-
Thanks guys... I extended the steering column. It was a bitch!Comment
Comment