pulling the motor on my cobra

[whitetrash]

so i have the motor mostly ready to pull. my question is do i deed to drain the a/c and power steering to pull it from the top or is there a way around it?

[butt86]

Just disconnect the compressor and pump from the motor and yank it on out

[whitetrash]

Just disconnect the compressor and pump from the motor and yank it on out

have you ever looked at how the hoses are ran on a 03 cobra? if it were just that simple i wouldnt have needed to ask

[TEAMJACOB]

have you ever looked at how the hoses are ran on a 03 cobra? if it were just that simple i wouldnt have needed to ask

Maybe he assumed it was another year and didn't read your Sig or has sigs turned off?

[03silversnake]

so i have the motor mostly ready to pull. my question is do i deed to drain the a/c and power steering to pull it from the top or is there a way around it?

Power steering and ac can both stay thier just unbolt them. Dont disconect your ac lines theirs no need to.

[Blackpony]

Just un bolt the compressor and ps pump from the block then pull from the top. I do it all the time at the shop, piece of cake.

[whitetrash]

ok thanks guys

[Whiteboy]

have you ever looked at how the hoses are ran on a 03 cobra? if it were just that simple i wouldnt have needed to ask

It's pretty simple

[whitetrash]

It's pretty simple

all my experiance is with small blocks. nothing under that hood looks simple in comparison

[whitetrash]

do you guys pull the eaton first or bring it out all together?

[john98gt]

U can pull motor tranny harness and intake and exhaust manifolds out through the top. Loosen the 8 bolts on the k member but dont take them all the way out.that will make it easier

[Junkie]

Make sure and put a pushrod motor back in, it'll save you some headache

[whitetrash]

U can pull motor tranny harness and intake and exhaust manifolds out through the top. Loosen the 8 bolts on the k member but dont take them all the way out.that will make it easier

trans is already out but the bell housing is still on there

[03silversnake]

do you guys pull the eaton first or bring it out all together?

Pull Eaton of first

[Captain Crawfish]

Make sure and put a pushrod motor back in, it'll save you some headache

agreed my next engine will be an LSx with some torque! after pulling the front cover off my old 4V i knew exactly why it broke!