Tweet
have you guys pushed through a 302? I know 500 HP is the limit, but is there a threshold on the amount of forced induction?
-
-
No.Originally posted by 89FivePointOh View PostOriginally posted by PGreenCobraOriginally posted by Trip McNeely -
If it is a stock compression motor normally you see guys running 8-10#s and at MOST 12#s which typically puts you with a HCI and boost setup at around the 450-500 rwhp mark.1993 Vibrant Red Cobra #1741.
If you want more inches - Stroke it!!!Comment
-
You wont push more than 11-12 with a 60-70mm on stock long block.
If it was a e85 car you might get some more power out of it, but the heads usually end up being the cause of not being able to push it harder.
Once you get a good/better set of heads on it, your usually at the block threshhold.Comment
-
I put down 396/477 through a stock 5.0
Stock heads don't like over 10-12lbsOne day at a time.Comment
-
Psi has absolutely nothling to do with anything mentioned.Ring and pinion specialistComment
-
Power, harmonics, rpms and luck. Psi, is just a measure of restriction. I've run 18psi through a stock block and it never split. Check out the stock block cronicles on www.theturboforums.com.DedComment
-
Originally posted by greenbullitt View Post
Originally posted by PGreenCobraOriginally posted by Trip McNeelyComment
-
This shit again?"If I asked people what they wanted, they would have said faster horses." - Henry FordComment
-
I usually ran about 32-34 psi in my front tires and 30-32 psi in my rear tires, unless I had the drag radials on kill, then I'd put about 15-18 psi in them.
Wait, were we talking about a different psi ?Comment
-
shit, I was doing it all wrong - my old 302 regularly saw 18-22psi. The new one is seeing somewhere around 32#.Comment
Comment