How do you align your doors? And install mirrors = fox

[DTM_Motorsports]

Thanks to our resident used parts supplier, ( thanks again Whiteboy ). I now have one of the
two doors on.

Questions are this

What's the best way you've found to get them aligned up good.
Also, how did you install mirrors with glass in?

This was a 2 and 1/2 hour ordeal for one door, Had to swap the wiring harness as well, as the
ones on these doors were cut off instead of unplugged, not a big deal as mine were still good.
Just took more time.

Also can't seem to get it to open from inside using the interior door handle .
But it works fine if you manually move the rod.
And yeah, it's hooked up, just isn't pushing the rod fully I guess .

One down




One to go

[ktm300hater]

Please tell me you are taking that wing off

[DTM_Motorsports]

Please tell me you are taking that wing off

I damn sure am.
I hate that thing.
Took it off once, but don't have a welder to weld up the holes. So back on it went.
Actually hoping to find a trunk lid with no rack either.....

[mstng86]

Whatever you do, put some new seals around the door jams. that way you won't have to adjust them again if you buy new seals later on.

[twisted93coupe]

I adjusted my doors with the front fenders off after i had it painted.It might of took 1-1 1/2 to adjust both doors.

[projectPONY]

Front fenders off. Align to the quarter panel and the rocker. Then align fenders to the doors.

Sent from my SPH-L710 using Tapatalk 2

[CWO]

trunk full of water > that wing

[ktm300hater]

I damn sure am.
I hate that thing.
Took it off once, but don't have a welder to weld up the holes. So back on it went.
Actually hoping to find a trunk lid with no rack either.....

I happen to have a rackless coupe trunk lid

[DTM_Motorsports]

I happen to have a rackless coupe trunk lid

Where?
How much?
Good shape?

[Rotortrash]

Looks like you've got a good start.

BTW, if you decide you don't want those wheels, I'd take them off your hands!

[DTM_Motorsports]

Looks like you've got a good start.

BTW, if you decide you don't want those wheels, I'd take them off your hands!

Honestly I'd probably trade them for something else.
They are brand new with brand new tires .
If I could find a set of real nice ponys with good tires I'd prolly do that

[ktm300hater]

Where?
How much?
Good shape?

Stephenville. 75. Only thing wrong with it is the lock cylinder hole needs some love. Apparently some one locked their self out at some point.

[Rotortrash]

Honestly I'd probably trade them for something else.
They are brand new with brand new tires .
If I could find a set of real nice ponys with good tires I'd prolly do that

My ponies are nice, but I'm not sure I'd call them "real nice". They do, however, have brand new tires on them. Where you located? I'll show you mine if you show me yours!