Dyno Tuning

[RJDCobra]

Andy @ Prime Tuning. He's here on the board.

X2

[91CoupeMike]

X3 on Andy

[91CoupeMike]

Get on a waiting list to sit in hpps lobby for 6 hours while manny surfs the web and eats his lunch. Car was on the rollers maybe 15-30minutes but we sat there for 5-6 HOURS.

[Whiteboy]

Get on a waiting list to sit in hpps lobby for 6 hours while manny surfs the web and eats his lunch. Car was on the rollers maybe 15-30minutes but we sat there for 5-6 HOURS.

That's why you drop it off

[91CoupeMike]

That's why you drop it off

Had an appointment at noon, left at 5-5:30.

Seemed like a waste of time.

[Blackpony]

That's why you drop it off

^^ this, every shop recommends dropping it off.

[justin91lx]

Well right now she seems to run rich and you can feel some missing in the mid rpms. Been reading some running timing 14-16 degrees. I'm not real educated on this. Only got 20 miles on the motor. Don't think its ideal to rev her up yet.

[justin91lx]

Well right now i have about 30 miles on the car. Would it be safe to tune?

[Cooter]

if you've gone 20 miles without putting it to the rug through all gears, you're not doing it right...

[justin91lx]

if you've gone 20 miles without putting it to the rug through all gears, you're not doing it right...

I had her to the floor a few time, just don't want to blow her up

[TX21]

I took mine to Gearheads in Arlington. Spent over 6 hours there to get 45 minutes of work done. Sucked balls. It was cheaper then HPP that's why I took it there. Dam thing was not right always died when I coasted in gear then pushed the clutch in would not idle. Surges real bad when you start it hot. Took it back and I spend another 4-5 hours for 30 minutes of work. And today the car is still not right. I am at the point I want to buy the Mega Squirt stuff so I can fucking do it myself. I got mods just like you TF H/C/I. No way I am leaving my car at any place so they can do it when they want and charge that much. I don't trust anyone.

[Lone Sailor]

I took mine to Gearheads in Arlington. Spent over 6 hours there to get 45 minutes of work done. Sucked balls. It was cheaper then HPP that's why I took it there. Dam thing was not right always died when I coasted in gear then pushed the clutch in would not idle. Surges real bad when you start it hot. Took it back and I spend another 4-5 hours for 30 minutes of work. And today the car is still not right. I am at the point I want to buy the Mega Squirt stuff so I can fucking do it myself. I got mods just like you TF H/C/I. No way I am leaving my car at any place so they can do it when they want and charge that much. I don't trust anyone.

Give Andy @ Prime Tuning a shot at it. My car was doing all the same shit, plus some, and he took care of it easily.

[One zero]

Archie King at Dallas mustang

Very knowledgeable and thorough. Will steer your right.

[justin91lx]

Tried today to get hold of andy at prime tuning by calling and left a message. Also left a pm but no word back.

[32vfromhell]

Both Manny at HPP and Travis at Gearheads are good tuners. I know both have spent more than their fair share of hours tuning my temperamental combo.