Wire bulkhead connectors?

[Mark04]

Ok Mark, I appreciate it - I'll bring one with me the next time I come out there.

The only problem is that these particular bulkheads have the rubber piece glued in place. If you look close at the orange piece, where it meets the metal piece - you can see the glue.

Is that a problem?

Nope.

[silverhatch]

It should be fine there is a small plastic tool you push into the front side that releases the tab and unlock them. This is the exact same connector used on a Peterbilt.

http://www.laddinc.com/our-products/online-catalog.html?layout=category

[Mark04]

It should be fine there is a small plastic tool you push into the front side that releases the tab and unlock them. This is the exact same connector used on a Peterbilt.

http://www.laddinc.com/our-products/...ayout=category

These are rear release. But the tools are the same. Depending on the size pin the tool changes but they look like:

[turbostang]

They don't show pricing on their site - any idea what these cost?

http://www.laddinc.com/our-products/online-catalog/item/557-drb12-60pce-l018-489.html

or maybe these?

http://www.laddinc.com/our-products/online-catalog/item/521-aec14-40pa-453.html

I guess there's two parts, they don't come as matched pairs?