Couple pics of my buddys 393w setup

[dangerous_sep]

lol its very simple to tell a 351 based motor apart from a 302. their is a noticeable distance from the distributor to the thermostat housing. the 351 obviously has the greater distance between there.

[matts5.0]

lol yeah, get him to join here..

[80coupe]

So, did he use the stock throttle body as a restrictor plate like Nascar?

yup extra 500 hp if taken off!

[musclestang89]

Tell him to post on the board. Also any track times?

[Snatch Napkin]

So, did he use the stock throttle body as a restrictor plate like Nascar?

[fbodyjohnny]

You can see a glimpse in the first picture at a bad angle. Doesn't look much bigger than one that comes with the kit to me, but who knows.

I'd love to see a dynosheet.

I'm going to be running that crank pulley, haven't measured it yet but it's pretty damn big

[Txstang1]

I said it in the other thread and I'll say it in here.

My lil 383w wants some of the 800hp beast. Let's do this !!

[barronj]

When he's ready to make serious power, I'm a serious buyer for that lightning lower/gt40 upper. I would love to go FI on my bronco.

[fbodyjohnny]

If you have never had a car with one of those blowers, you will love it. Just make sure and tune it right.

sooner or later I'll get a tune but for now,, I'm just gonna throw on the new 42# injectors, boost reference regulator, and boost timing master and tweak it to my liking. should be just fine. I'm just curious to see what it's gonna put down. my engine is pretty well built up

[Randy]

Maybe the pack of smokes makes the extra HP???

[AdamLX]

I didn't think to look until now but he could have an 8" crank pulley like they used in Renegade class but shit you can't tell in that pic.

I want to see a dyno sheet!

You can see a glimpse in the first picture at a bad angle. Doesn't look much bigger than one that comes with the kit to me, but who knows.

I'd love to see a dynosheet.

[lee earley]

I wont disagree the power it makes. But Im still amazed by people who smoke these days!

[Broncojohnny]

The S-trim can only flow so much air. Now if it was a T-trim or YS then it would be reasonable, but an S-trim just doesn't have the ability to flow enough air to support 1000hp at the crank.

Plus he needs a smaller pulley (think alternator pulley) to make 14psi on what should be a good breathing motor to make that much power.

Now I don't doubt that it's probably making upwards of 800hp at the crank.

I didn't think to look until now but he could have an 8" crank pulley like they used in Renegade class but shit you can't tell in that pic.

I want to see a dyno sheet!

[AdamLX]

ok because in the last I've watched his car smoke the dogshit out of modded out 1000cc bikes so I guess I'm just makin shit up right? I guess when I watched him run bikes I was just seein shit? hm I'll go get my eyes checked but I'm pretty sure I watched him pull away from them pretty damn hard. he's not gonna give me a dyno sheet. idk why you guys think it's not possible to hit 800 with a build like that, it is what it is. I coulda just lied and said it's only puttin down 500 but I don't lie when I talk about someone else's car.

The S-trim can only flow so much air. Now if it was a T-trim or YS then it would be reasonable, but an S-trim just doesn't have the ability to flow enough air to support 1000hp at the crank.

Plus he needs a smaller pulley (think alternator pulley) to make 14psi on what should be a good breathing motor to make that much power.

That S-trim will be a world of difference over what you have on the car now though.

[Broncojohnny]

Thank you, for not bein a dick and understanding that I am only repeating what he told me about it and like I would know any different... I'm excited to put it on mine along with all the other goodies to run with it. should drive like a completely different car

If you have never had a car with one of those blowers, you will love it. Just make sure and tune it right.