Originally posted by Grimpala
View Post
Announcement
Collapse
No announcement yet.
So you want a fully automatic firearm...
Collapse
This is a sticky topic.
X
X
-
^^^^ That is too bad. When the PD was on HV road across the street from the A frame house y'all used to have a very large stash of old M16s and a few M14s that were government giveaways. I wonder what happened to them? Given how the old PD was ran I bet that they are at home in the closets of a few of the officers who used to work there.
Leave a comment:
-
Originally posted by FastFord19 View Posthttp://www.highlandvillage.org/362/Fingerprinting
Highland Village. They want you to be a resident but I will print anymore.
Does the PD still have all of the Nam era M16s? I used to shoot them with a few of the officers who were on the force when I was in my teens at a makeshift range that they had set up in the power line right of way off of Highland Village Rd.
Leave a comment:
-
Denton?
I talked to ours and they dont offer the service. Nearest department is Carrollton for $10 a card and only from 5-6:30pm on Mondays.
Leave a comment:
-
Originally posted by NoClassic View PostI do have one of the print specific ink pads on the way but did not order a card holder. Good to hear its not that difficult.
Yes you can still do your own prints.
Leave a comment:
-
I do have one of the print specific ink pads on the way but did not order a card holder. Good to hear its not that difficult.
Yes you can still do your own prints.
Leave a comment:
-
It's best if you buy finger print specific ink. I've seen people try that stuff with other inks and it doesn't work. But then i also bought a $7 card holder off of eBay. I Velcrod it to my work table edge. It surprisingly takes a fair amount of ink, but just paractice rolling and pressure and you'll eventually get it. I'm no expert and I've never had any of mine be rejected.
Leave a comment:
-
Does anyone have experience rolling finger prints? I am going to try it myself but wanted another option if I cant get it right.
Leave a comment:
Leave a comment: